- 1UPSC CSE I - 2021In a pressure cooker, the temperature at which the food is cooked depends mainly upon which of the following?
- Area of the hole in the lid
- Temperature of the flame
- Weight of the lid
Select the correct answer using the code given below. - 2UPSC CSE I - 2011The surface of a lake is frozen in severe winter, but the water at its bottom is still liquid. What is the reason ?
- 3UPSC CSE I - 2006
Which one of the following is printed on a commonly used fluorescent tube light?
- 4UPSC CSE I - 2003
Consider the following statements:
- Steam at 100°C and boiling water at 100°C contain same amount of heat.
- Latent heat of fusion of ice is equal to the latent heat of vaporization of water.
- In an air-conditioner, heat is extracted from the room air at the evaporator coils and is rejected out at the condenser coils.
Which of these statements is/are correct?
- 5UPSC CSE I - 2001
A hollow sphere of radius R, a hollow cube of side R and a thin circular plate of radius R, made up of the same material, are all heated to 20°C above room temperature. When left to cool in the room, which of them will reach the room temperature first?
- 6UPSC CSE I - 2001
When water is heated from 0ºC to 10ºC, its volume:
- 7UPSC CSE I - 2001
Assertion (A): The boiling point of water decreases as the altitude increases.
Reason (R): The atmospheric pressure increases with altitude.
Codes:
- 8UPSC CSE I - 2001
Assertion (A): A piece of copper and a piece of glass are heated to the same temperature. When touched, thereafter, the copper piece appears hotter than the glass piece.
Reason (R): The density of copper is more than that of glass.
Codes:
- 9UPSC CSE I - 1999
Assertion (a) : To dih4te sulphuric acid, acid is added to water and not water to acid.
Reason (K) : Specific heat of water is quite 1arge - 10UPSC CSE I - 1999
Strips of two metals A and B are firmly jointed together as shown in the figure.
On heating, A expands more than B does. If this jointed strip is heated, then it will appear as
- 11UPSC CSE I - 1999
Consider the following statements:
An ordinary light bulb has a rather short life because the:
- filament wire is not uniform.
- bulb cannot be evacuated completely.
- wires supporting the filament melt at high temperatures.
Which of the above statements are correct?